导读：水性环氧树脂为主要成分配合乳化羟基树脂颜料分装供应的水性环氧聚氨酯防腐涂料。超强的附着力、坚硬的漆膜和光亮耐水性优异的耐潮湿性，耐溶剂、耐化学品等特点，性能施工方法如下： Takeaway: waterborne epoxy resin as the main ingredients with hydroxyl resin emulsion water-based epoxy polyurethane anticorrosion coating pigment packing supplies. Strong adhesion, hard coating and bright water resistance excellent moisture resistance, solvent resistance, chemical resistance and other characteristics, performance and construction method is as follows: 水性环氧聚氨酯防腐涂料的性能取决于配方设计的合理性 任何产品使用寿命的长短在于基材处理十分合格，混泥土基层处理存在的问题如下： Any product service life is the length of the base material handling very qualified, concrete problems existing in the basic level processing is as follows: 1、油污较多的地面：需要用用10%——15%的盐酸清洗混凝土表面，待反应完全后（不再产生气泡），再用清水冲洗，并配合毛刷刷洗，此法可清除泥浆层并得到较细的粗糙度。 1, smeary more ground: need to use 10% - 15% hydrochloric acid cleaning concrete surface, after waiting for reaction completely (no bubbles), reoccupy clear water flushing, and cooperate with the hair brush wash, this method can remove a layer of mud and get a fine roughness. 2、大面积场地：用喷砂或电磨机清楚表明的突出物，松动颗粒，破坏毛细孔，增加附着面积。用吸尘器清理表面沙粒、杂质、灰尘。 2, large area ground: with sand or electric grinder clear protrusions, loose particles, destroy the wool stoma, increase the adhesion area. Vacuum cleaning sand surface, impurity and dust. 3、表面不平整：对于有凹陷、坑洞的表面，映使用腻子修补找平。处理之后的表面要求坚硬、平整、不起砂、清洁无油，并且具有一定粗糙度的效果。 3, the surface is uneven, with the surface of the sag, hole, use putty to repair the leveling. After processing the surface of the hard, smooth, no sand, clean oil, and the effect of a certain roughness. 4、钢铁表面处理：除锈级别较低，喷砂除锈Sa2级或手工St2级，有一定的粗糙度，表面无油。 4, iron and steel, surface treatment, derusting level is low, sandblasting derusting Sa2 level or manual St2 level, there is a certain roughness, surface without oil. 只有达到这些施工前的准备工作，和基层的处理才能在适宜的环境下进行施工，发挥出最大产品性能。 Only meet these preparation work before construction, and primary processing can in a suitable environment for the construction, the maximum product performance play. |
